The Influence of BBC's Lion, Witch, and Wardrobe on Popular Culture

The BBC adaptation of "The Lion, the Witch, and the Wardrobe" is a television series based on the beloved children's book written by C.S. Lewis. The series was first broadcasted in 1988 and consists of three episodes, each running for approximately 30 minutes. It was directed by Marilyn Fox and produced by Paul Stone. "The Lion, the Witch, and the Wardrobe" is the first book in the Chronicles of Narnia series and tells the magical story of four siblings - Peter, Susan, Edmund, and Lucy - who stumble upon a wardrobe that acts as a portal to the enchanted land of Narnia.

"The Lion, the Witch, and the Wardrobe" is the first book in the Chronicles of Narnia series and tells the magical story of four siblings - Peter, Susan, Edmund, and Lucy - who stumble upon a wardrobe that acts as a portal to the enchanted land of Narnia. In Narnia, they discover a land frozen in eternal winter under the rule of the evil White Witch. The BBC adaptation brings this enchanting tale to life with its captivating storytelling and impressive visual effects.

Spare Tire Holder Suggestions

I have a 2014 21’ Key West Bay Reef that I would like to attach 2 spares to my Magic Tilt dual axle trailer. Any suggestions?

Sent from my iPhone using Tapatalk

Oct 22, 2021 #2 2021-10-22T17:41

I used one of these on my single axle Magic Tilt. I had to add some spacers under it to get it fit on my trailer, which has four inch tall I-beams. If your I-beams are at least five inches tall it should fit fine.
https://www.easternmarine.com/aluminum-i-beam-spare-tire-carrier-86064-0

You might want to consider using one of the tire mounts that uses a bearing hub instead of lug nuts to mount the spare. You'll have a spare hub in case of a bearing failure, and you won't need a lug wrench to change the tire, just a pair of pliers.

Oct 22, 2021 #3 2021-10-22T19:08

So you had to drill into trailer then correct?

Sent from my iPhone using Tapatalk

Oct 23, 2021 #4 2021-10-23T00:59

Yes, you have to drill four 1/2 inch holes in the web. (The instructions say 5/8, but if you drill them accurately half inch works.) I put mine close to the front end of the beam where it shouldn't affect the trailer's strength. The mount comes with grade 5 steel bolts; I replaced mine with 304 stainless. They want you to put a layer of duct tape between the galvanized mount and aluminum beam to prevent galvanic action, which I did.

Oct 23, 2021 #5 2021-10-23T11:58

Yes, you have to drill four 1/2 inch holes in the web. (The instructions say 5/8, but if you drill them accurately half inch works.) I put mine close to the front end of the beam where it shouldn't affect the trailer's strength. The mount comes with grade 5 steel bolts; I replaced mine with 304 stainless. They want you to put a layer of duct tape between the galvanized mount and aluminum beam to prevent galvanic action, which I did.

You might want to re-think the stainless bolts. It's likely that they want the grade 5 bolts in there so that the mounting flange of the tire holder acts as a flitch plate to offset the effect of drilling the holes in the i-beam. How critical, I cannot say without some calculations. But I see that a lot with trailer hardware. Quite a few parts on aluminum trailers use galvanized steel and galvanized grade 5 or grade 8 bolts.

Oct 23, 2021 #6 2021-10-23T12:27

This is the one I’m thinking about.

Sent from my iPhone using Tapatalk

Oct 23, 2021 #7 2021-10-23T23:16

That will work if your trailer tongue is long enough. Mine isn't. Note that the location of the spare will affect how sharp you can jackknife the trailer.

The Tie Down Engineering stuff is well made. Hot-dipped galvanized, not just electroplated.

Oct 23, 2021 #8 2021-10-23T23:45

You might want to re-think the stainless bolts. It's likely that they want the grade 5 bolts in there so that the mounting flange of the tire holder acts as a flitch plate to offset the effect of drilling the holes in the i-beam. How critical, I cannot say without some calculations. But I see that a lot with trailer hardware. Quite a few parts on aluminum trailers use galvanized steel and galvanized grade 5 or grade 8 bolts.

I can't see how slightly stronger bolts will make the I-beam any stronger. At any rate, I placed the mount in a low-stress area, near the end of the beam and where it's supported by the galvanized trailer tongue.

Oct 24, 2021 #9 2021-10-24T00:33

You might want to re-think the stainless bolts. It's likely that they want the grade 5 bolts in there so that the mounting flange of the tire holder acts as a flitch plate to offset the effect of drilling the holes in the i-beam. How critical, I cannot say without some calculations. But I see that a lot with trailer hardware. Quite a few parts on aluminum trailers use galvanized steel and galvanized grade 5 or grade 8 bolts.

I can't see how slightly stronger bolts will make the I-beam any stronger. At any rate, I placed the mount in a low-stress area, near the end of the beam and where it's supported by the galvanized trailer tongue.

It's how the loads in the i-beam transfer to the plate on the tire holder -- the plate becomes a reinforcement to offset the weakening of the i-beam from holes. Many different bits of trailer hardware are designed to do this. It will be dependent on the strength of the bolts to transfer the load. May not matter in this case, but that is likely why grade 5 bolts were specified for something as simple as a tire holder. SS bolts are going to be like rubber in comparison.

Home :: PV - Spare Tire Mounts :: PV1900 ~ SPARE TIRE MOUNT HORIZONTAL WITH LOCK

The series stays true to the original story, capturing the essence of Lewis' imagination and introducing viewers to the fascinating world of Narnia. The performances by the cast are commendable, particularly the young actors who portray the Pevensie children. The production design and costumes in the series are well-crafted, creating a believable and immersive world of Narnia. The snowy landscapes and magical creatures, such as talking animals and mythical creatures, are brought to life with attention to detail. One of the highlights of the BBC adaptation is the portrayal of Aslan, the wise and powerful lion who becomes the symbol of hope for the inhabitants of Narnia. Aslan's character is central to the plot and his portrayal in the series is majestic and captivating. Overall, the BBC adaptation of "The Lion, the Witch, and the Wardrobe" is a faithful and enchanting retelling of C.S. Lewis' beloved book. It captures the wonder and magic of Narnia, making it a must-watch for both fans of the book and new viewers alike..

Reviews for "The Enchanting World of Narnia: A Visual Tribute to BBC's Lion, Witch, and Wardrobe"

1. Jane - 2/5 - I was really disappointed with the BBC adaptation of "The Lion, the Witch and the Wardrobe." It completely missed the magical and enchanting essence of the original book. The characters felt flat, and the acting was mediocre at best. The special effects were underwhelming, especially for a fantasy story. The pacing was off, with some scenes feeling rushed while others dragged on. Overall, it lacked the charm and wonder that makes the story so beloved.

2. Mark - 3/5 - While I didn't hate the BBC version of "The Lion, the Witch and the Wardrobe," I also didn't think it was anything special. The production quality was quite low, and it felt dated. The costumes and set design were unimpressive, and the CGI was poorly executed. The acting was mediocre, and it failed to capture the emotional depth of the book. It's a shame because this is a beloved story, and this adaptation didn't do it justice.

3. Emily - 2/5 - As a fan of the "The Lion, the Witch and the Wardrobe" book series, I was excited to see the BBC adaptation. However, I was hugely disappointed. The performances were wooden and lacked chemistry, making it difficult to connect with the characters or their journey. The production value was low, with lackluster special effects and unimpressive costumes. The pacing was off, with some scenes feeling rushed while others dragged on. I wouldn't recommend this version to anyone who wants to experience the true magic of C.S. Lewis' masterpiece.

The Success of BBC's Lion, Witch, and Wardrobe: A Journey into Narnia