The Curse of the Crimson Altar is a horror film released in 1968. Directed by Vernon Sewell, the movie is based on the short story "The Dreams in the Witch House" by H.P. Lovecraft. It follows the story of a young woman named Nan Barlow who travels to a remote village in England to research her family's history for a college project. Upon arriving in the village, Nan becomes entangled in a web of witchcraft and satanic rituals.
Fit the new liner on the shelf so it lays flat. (Unroll and place the new liners pattern side-up in sunlight for a few minutes if needed to make them more pliable.) For a large surface, you may want to use painter’s tape or a small weight to hold the liner in place. Our liners are trimmed slightly under dimensions for ease-of-fit, so they should lay flat on all corners without pushing up on any sides.
This process describes installation into a cabinet, but the steps are basically the same for free-hanging shelves, cubbies, furniture, drawers or most other surfaces. Without disturbing the alignment, lift an edge of the liner and peel back a small 1 2 1 12-25 mm strip of the backing and crease it back onto itself so the adhesive is exposed.
Upon arriving in the village, Nan becomes entangled in a web of witchcraft and satanic rituals. She discovers a mysterious cult led by the sinister J.D.
Chic Shelf Paper
Shelf paper is simple to install and with a little care, wonderful-looking results are simple to achieve. For first-timers, we recommend you start with a non-obvious surface (either a high or low shelf for example) to understand the installation technique. Remember, the backing is your friend, do not remove it until you’re ready to stick it down. If you don’t want to use adhesive contact paper or have questions, see which contact paper material to use. In the following instructions, we’ll guide you through our step-by-step process on how to properly install adhesive contact shelf paper and adhesive shelf liners.
Overview: Installing adhesive contact shelf paper
- Clean all surfaces
- Cut product to size (if necessary)
- Test fit and position product
- Expose a small strip of adhesive and secure material in place
- Remove the backing a little at a time
- Smooth the paper outwards starting from the center
- If the alignment moved, carefully lift and re-apply
Tools for installing adhesive contact shelf paper
- A putty knife
- A good commercial cleaner or TSP (Tri-Sodium Phosphate)
- Medium grit (150) sandpaper (optional)
- Low-tack masking tape
- Hand squeegee (shipped with applicable orders) or credit card
This process describes installation into a cabinet, but the steps are basically the same for free-hanging shelves, cubbies, furniture, drawers or most other surfaces.
Step 1: Prepare your surfaces
Preparation is the first step to a good job – the goal is to begin with a clean, flat surface. New cabinets should be thoroughly vacuumed, then gone over with a damp cloth. For older surfaces, remove any loose particles, dust, oil, wax, or other contaminants by cleaning with a good cleaner like TSP (available in the paint section of most hardware stores). Dry thoroughly before installing your new shelf paper. Note: Since we use a moderate tack adhesive, edges or corners will lift if the adhesive is contaminated with dirt or dust.
Step 2: Layout your adhesive contact paper for proper fitment
Fit the new liner on the shelf so it lays flat. (Unroll and place the new liners pattern side-up in sunlight for a few minutes if needed to make them more pliable.) For a large surface, you may want to use painter’s tape or a small weight to hold the liner in place. Our liners are trimmed slightly under dimensions for ease-of-fit, so they should lay flat on all corners without pushing up on any sides.
Step 3: Peel back a small strip of the backing of your adhesive contact paper
Expose a small strip of adhesive. Without disturbing the alignment, lift an edge of the liner and peel back a small 1/2″ – 1″ (12-25 mm) strip of the backing and crease it back onto itself so the adhesive is exposed. Replace the lifted edge of the liner with the contact area down.
Step 4: Apply pressure with a squeegee to apply exposed liner to surface
Check final alignment and then apply light pressure with your thumb or finger over the section with exposed adhesive. Use moderate pressure with the soft edge of the hand squeegee to gently smooth the contact area. Work only from the center towards the edges. This will ensure any trapped air bubbles are expressed. If an air bubble is trapped, lift the edge of the liner and move the air bubble to the perimeter with the squeegee.
Step 5: Continue to remove backing in small segments
Remove the backing in small segments. The contact area should hold quickly. Peel back the liner to expose a new area of adhesive. Originating from the center, use the squeegee to lay the liner flat using a front-to-back, back-to-front motion. Do not stretch the liner. Overlap strokes and always work from an adhered section. Continue until all the backing is removed.
Step 6: Work your way towards the edges to ensure adhesion of contact paper
Gently push the firm edge of the squeegee into the corners and around the perimeter to ensure good adhesion. If an air bubble is trapped, you can use a sewing needle or pin to lance the bubble, then smooth that area with the squeegee towards the pinhole.
Step 7: Repeat until complete
Repeat until complete. Then stand back to admire your handiwork, your awesome pattern choices, and how great your completed project looks!
Make sure to check out our FAQs to see more commonly asked questions, idea boards on Pinterest, or contact us with any concerns you may have.
Morley, who intends to use her as a sacrifice in a ritual at the crimson altar. As Nan delves deeper into the village's dark secrets, she uncovers a curse that has haunted the town for centuries. The movie features an eerie atmosphere with gothic undertones, which is characteristic of Lovecraft's works. It combines elements of supernatural horror, suspense, and cult rituals to create a chilling tale that keeps the audience on the edge of their seats. The Curse of the Crimson Altar boasts an impressive cast, with notable performances by Barbara Steele, Christopher Lee, and Boris Karloff. Steele, known for her role in Italian gothic horror films, delivers a captivating performance as the damsel in distress, adding a touch of vulnerability to her character. Lee, a prominent figure in the horror genre, portrays the enigmatic cult leader with his signature charisma and commanding presence. And Karloff, an icon of classic horror, brings his unique charm in a supporting role. Despite being a lesser-known film compared to other horror classics of the time, The Curse of the Crimson Altar is highly regarded by fans of Lovecraftian horror. It captures the essence of Lovecraft's atmospheric storytelling and explores themes of ancient evils and the fragility of human sanity. Overall, The Curse of the Crimson Altar is a thrilling and eerie film that explores the sinister secrets hidden within a gothic village. Its suspenseful plot, talented cast, and haunting atmosphere make it a must-watch for fans of Lovecraft and classic horror..
Reviews for "Ancient Curses and Mysterious Relics: The Legend of the Crison Altar"
1. Jane - 2/5 stars
I was extremely disappointed with "Curse of the Crimson Altar". The storyline was confusing and lacked depth. The characters were one-dimensional and I couldn't connect with any of them. The visuals were also underwhelming, with poor special effects that took away from the overall viewing experience. Overall, I found the movie to be a waste of time and wouldn't recommend it to anyone looking for a thrilling horror film.
2. Mike - 1/5 stars
I have to say, "Curse of the Crimson Altar" is one of the worst movies I've ever seen. The acting was atrocious, with wooden performances that made it almost laughable. The plot was predictable and cliché, and I found myself getting bored halfway through. The dialogue was also cringe-worthy and lacked any substance. Save yourself the trouble and avoid this movie at all costs.
3. Sarah - 2/5 stars
"Curse of the Crimson Altar" had potential, but it failed to deliver. The pace of the movie was extremely slow, and I found myself losing interest quickly. The scares were minimal, and those that were present felt forced and predictable. The cinematography was lackluster, with uninspired camera work and dull visuals. Overall, I was disappointed with this film and would not recommend it to horror enthusiasts.
4. Mark - 1/5 stars
"Curse of the Crimson Altar" was a complete waste of my time and money. The plot was convoluted and made no sense, leaving me confused throughout the entire film. The acting was subpar, with performances that felt forced and unnatural. The lack of character development made it impossible for me to care about what was happening on screen. I found myself checking my watch, wishing for the movie to end. I would advise others to avoid this disappointment.