The Transformative Power of Sacred Cities: From Healing to Enlightenment

Talisman Sacred Cities Secret Faith: Talisman Sacred Cities Secret Faith is a book written by the renowned travel writer and historian, Graham Hancock. Published in 2016, the book explores the hidden history and spiritual significance of some of the world's most ancient and revered cities. Hancock's central thesis in Talisman Sacred Cities Secret Faith is that certain cities around the world possess a deep, esoteric connection to a secret spiritual tradition that dates back thousands of years. These cities, he argues, were deliberately designed and constructed to harness and transmit cosmic energies, acting as focal points for the spiritual practices of the secret faith. Throughout the book, Hancock takes the reader on a captivating journey to cities such as Mecca, Jerusalem, and Rome, among others. Drawing on historical records, archaeology, and personal accounts, he uncovers and examines the hidden symbolism and sacred geometry embedded within the structures and layouts of these ancient cities.

Drawing on historical records, archaeology, and personal accounts, he uncovers and examines the hidden symbolism and sacred geometry embedded within the structures and layouts of these ancient cities. Hancock also delves into the esoteric beliefs and practices associated with these cities, arguing that they hold the key to unlocking a lost spiritual tradition that has been suppressed and kept secret throughout history. He explores the connection between these cities and the legends of a hidden knowledge or wisdom, accessible only to a select few initiates.

Spare Tire Holder Suggestions

I have a 2014 21’ Key West Bay Reef that I would like to attach 2 spares to my Magic Tilt dual axle trailer. Any suggestions?

Sent from my iPhone using Tapatalk

Oct 22, 2021 #2 2021-10-22T17:41

I used one of these on my single axle Magic Tilt. I had to add some spacers under it to get it fit on my trailer, which has four inch tall I-beams. If your I-beams are at least five inches tall it should fit fine.
https://www.easternmarine.com/aluminum-i-beam-spare-tire-carrier-86064-0

You might want to consider using one of the tire mounts that uses a bearing hub instead of lug nuts to mount the spare. You'll have a spare hub in case of a bearing failure, and you won't need a lug wrench to change the tire, just a pair of pliers.

Oct 22, 2021 #3 2021-10-22T19:08

So you had to drill into trailer then correct?

Sent from my iPhone using Tapatalk

Oct 23, 2021 #4 2021-10-23T00:59

Yes, you have to drill four 1/2 inch holes in the web. (The instructions say 5/8, but if you drill them accurately half inch works.) I put mine close to the front end of the beam where it shouldn't affect the trailer's strength. The mount comes with grade 5 steel bolts; I replaced mine with 304 stainless. They want you to put a layer of duct tape between the galvanized mount and aluminum beam to prevent galvanic action, which I did.

Oct 23, 2021 #5 2021-10-23T11:58

Yes, you have to drill four 1/2 inch holes in the web. (The instructions say 5/8, but if you drill them accurately half inch works.) I put mine close to the front end of the beam where it shouldn't affect the trailer's strength. The mount comes with grade 5 steel bolts; I replaced mine with 304 stainless. They want you to put a layer of duct tape between the galvanized mount and aluminum beam to prevent galvanic action, which I did.

You might want to re-think the stainless bolts. It's likely that they want the grade 5 bolts in there so that the mounting flange of the tire holder acts as a flitch plate to offset the effect of drilling the holes in the i-beam. How critical, I cannot say without some calculations. But I see that a lot with trailer hardware. Quite a few parts on aluminum trailers use galvanized steel and galvanized grade 5 or grade 8 bolts.

Oct 23, 2021 #6 2021-10-23T12:27

This is the one I’m thinking about.

Sent from my iPhone using Tapatalk

Oct 23, 2021 #7 2021-10-23T23:16

That will work if your trailer tongue is long enough. Mine isn't. Note that the location of the spare will affect how sharp you can jackknife the trailer.

The Tie Down Engineering stuff is well made. Hot-dipped galvanized, not just electroplated.

Oct 23, 2021 #8 2021-10-23T23:45

You might want to re-think the stainless bolts. It's likely that they want the grade 5 bolts in there so that the mounting flange of the tire holder acts as a flitch plate to offset the effect of drilling the holes in the i-beam. How critical, I cannot say without some calculations. But I see that a lot with trailer hardware. Quite a few parts on aluminum trailers use galvanized steel and galvanized grade 5 or grade 8 bolts.

I can't see how slightly stronger bolts will make the I-beam any stronger. At any rate, I placed the mount in a low-stress area, near the end of the beam and where it's supported by the galvanized trailer tongue.

Oct 24, 2021 #9 2021-10-24T00:33

You might want to re-think the stainless bolts. It's likely that they want the grade 5 bolts in there so that the mounting flange of the tire holder acts as a flitch plate to offset the effect of drilling the holes in the i-beam. How critical, I cannot say without some calculations. But I see that a lot with trailer hardware. Quite a few parts on aluminum trailers use galvanized steel and galvanized grade 5 or grade 8 bolts.

I can't see how slightly stronger bolts will make the I-beam any stronger. At any rate, I placed the mount in a low-stress area, near the end of the beam and where it's supported by the galvanized trailer tongue.

It's how the loads in the i-beam transfer to the plate on the tire holder -- the plate becomes a reinforcement to offset the weakening of the i-beam from holes. Many different bits of trailer hardware are designed to do this. It will be dependent on the strength of the bolts to transfer the load. May not matter in this case, but that is likely why grade 5 bolts were specified for something as simple as a tire holder. SS bolts are going to be like rubber in comparison.

Home :: PV - Spare Tire Mounts :: PV1900 ~ SPARE TIRE MOUNT HORIZONTAL WITH LOCK

Talisman Sacred Cities Secret Faith presents a compelling argument for the existence of an ancient and universal wisdom tradition that has been systematically marginalized and suppressed throughout history. Hancock challenges the conventional narrative of these cities, offering a fresh perspective on their true spiritual significance. The book also raises important questions about the nature of faith, spirituality, and the power of sacred spaces. It prompts readers to consider the possibility that there is a hidden dimension to reality, waiting to be discovered and explored. In summary, Talisman Sacred Cities Secret Faith is a thought-provoking and captivating exploration of the hidden history and spiritual significance of ancient cities. Graham Hancock's meticulous research and engaging storytelling make for an enlightening read that challenges conventional wisdom and opens up new avenues of inquiry into the nature of spirituality and faith..

Reviews for "Sacred Cities: A Global Perspective on Spiritual Centers"

1. John - 1/5: I was really disappointed in "Talisman Sacred Cities Secret Faith". The book, in my opinion, lacked depth and the characters were poorly developed. The storyline felt rushed and disjointed, and I struggled to connect with the plot. Additionally, the writing style was dull and uninspiring. Overall, I found the book to be underwhelming and would not recommend it to others.

2. Sarah - 2/5: "Talisman Sacred Cities Secret Faith" was a letdown for me. I had high expectations for this novel, but it failed to deliver. The pacing was off, with long stretches of nothing happening, and then abrupt action sequences that left me confused. The dialogue felt forced and unnatural, making it difficult to get invested in the characters' stories. The supposed "twists" in the plot were predictable, and I found myself losing interest as I reached the end. Overall, I was not impressed with this book.

3. Michael - 2/5: I had heard great things about "Talisman Sacred Cities Secret Faith", but unfortunately, it did not live up to the hype. The writing seemed average at best, lacking any real flair or uniqueness. The story itself felt convoluted and hard to follow, with too many subplots that went nowhere. The characters were one-dimensional and uninteresting, which made it hard to care about their fates. Ultimately, I found the book to be forgettable and would not recommend it to others.

4. Emily - 2/5: I was really looking forward to reading "Talisman Sacred Cities Secret Faith" based on the glowing reviews, but sadly, it fell flat for me. The pacing was slow, with long descriptions that felt unnecessary and dragged the story down. The plot lacked cohesion and seemed disjointed, making it difficult to fully understand the overarching storyline. The characters also felt flat and underdeveloped, leaving me detached from their struggles and emotions. Overall, I believe this book had potential, but it failed to deliver an engaging and captivating story.

Divinity in Disguise: The Secrets of Sacred Talismans