The Parentless Witch as a Subversion of Traditional Gender Roles

Once upon a time in a small village nestled in the heart of a dense forest, there lived a young girl named Luna. Luna was no ordinary girl, for she possessed magical powers that she had inherited from her ancestors. However, she was different from any other witch in the village, for Luna was a parentless witch. No one knew how Luna came to be parentless, as she was found abandoned at the entrance of the village when she was just a baby. The villagers, taking pity on the helpless infant, decided to take her in and raise her as their own. They did not fear her powers; instead, they saw them as a gift that could be nurtured for the greater good.

Old thermostat wiring

So I m wondering if there is any thermostat on the market that has this capability, or am I just way out of line for expecting a thermostat to provide me with this kind of esoteric detail. Well I went downstairs to make sure the filter wasn t crazy clogged up or anything like that, maybe keeping it from kicking on, it was just a thought.

They did not fear her powers; instead, they saw them as a gift that could be nurtured for the greater good. Growing up, Luna was a kind and gentle soul. She was always eager to help others and lend a helping hand whenever needed.

How do I test a furnace without a thermostat ?

I have a furnace that has no thermostat wires ran to it. Meaning, all the wires that were on the circuit board of the furnace are taken off. I wanted to test the blower motor so I ran a switch to it . When I turn it on , the blower motor spins about a half an inch . I'm assuming I have to wire the circuit board. How do I do this.

larry4406

Well-known member

"Red and White makes my furnace light".

Literally, connect the red and white terminals on the board and it will go into start up sequence and run full tilt for heat. Check the gas solenoid as many have an on/off switch and make sure it is on.

dogdog

Well-known member

Bert_

Well-known member

R is 24v power, W is call for heat, if it has a G terminal that is fan only.

R+W will be normal heating.

Jberger93

Well-known member

bubinga

Well-known member

R is 24v power, W is call for heat, if it has a G terminal that is fan only.

R+W will be normal heating.

I'm going to piggyback on this thread.
I want to test my thermostat, jumping at the terminals on the back of the thermostat.
So, if R and W is call for heat, what would I jump
R to, to see if my A/C kicks on?
(This is an older style round thermostat,
No digital readout)

Jim greengo

I'm going to piggyback on this thread.
I want to test my thermostat, jumping at the terminals on the back of the thermostat.
So, if R and W is call for heat, what would I jump
R to, to see if my A/C kicks on?
(This is an older style round thermostat,
No digital readout)

bubinga

Well-known member

Thank you Jim
So I would jump all 3?
Red R 24 v and Green
Will power my fan, and jumpering in Yellow Y (Or blue) will start the sequence for the air conditioning correct?

Jim greengo

Thank you Jim
So I would jump all 3?
Red R 24 v and Green
Will power my fan, and jumpering in Yellow Y (Or blue) will start the sequence for the air conditioning correct?

bubinga

Well-known member

Jim greengo

bubinga

Well-known member

Well I went downstairs to make sure the filter wasn't crazy clogged up or anything like that, maybe keeping it from kicking on, it was just a thought.
The filter is not too terribly dirty or anything.
Now I have not tried to jump the thermostat out yet.
However, when I went down to check the filter the blower motor was running (the fan switch is set to automatic)
Also the unit is running outside.
Could that still be a malfunction in the thermostat perhaps from the R terminal, to the yellow terminal of the thermostat?
I know it's definitely not cooling though I have the thermostat set to about 60° and the thermometer is reading 68 to 70°.
Thank you!

Jim greengo

Try removing thermostat and see if it shuts down.Depending on how new the furnace is ,it could also be a control board/relay problem.
Get that part figured out 1st,then throw a set of gauges on the outside unit to see what its doing.

dogdog

Well-known member

Well I went downstairs to make sure the filter wasn't crazy clogged up or anything like that, maybe keeping it from kicking on, it was just a thought.
The filter is not too terribly dirty or anything.
Now I have not tried to jump the thermostat out yet.
However, when I went down to check the filter the blower motor was running (the fan switch is set to automatic)
Also the unit is running outside.
Could that still be a malfunction in the thermostat perhaps from the R terminal, to the yellow terminal of the thermostat?
I know it's definitely not cooling though I have the thermostat set to about 60° and the thermometer is reading 68 to 70°.
Thank you!

if you are on heat setting, your thermostat is set at 60 and your temp is at 70, it should not run regardless of fan is on automatic or not.

but if you are on Cooling mode, your thermostat is set at 60, and your temp is at 70 it will try to cool the house down to 60.

check and make sure what mode your thermostat is set to. ? heating or cooling.

bubinga

Well-known member

if you are on heat setting, your thermostat is set at 60 and your temp is at 70, it should not run regardless of fan is on automatic or not.

but if you are on Cooling mode, your thermostat is set at 60, and your temp is at 70 it will try to cool the house down to 60.

check and make sure what mode your thermostat is set to. ? heating or cooling.

bubinga

Well-known member

Try removing thermostat and see if it shuts down. Depending on how new the furnace is ,it could also be a control board/relay problem.
Get that part figured out 1st,then throw a set of gauges on the outside unit to see what its doing.

Remove the thermostat and see if the blower shuts down you mean?
Can I just remove the wire to the R terminal, or do I have to remove all of the wires?
Thanks Guys!

Side note, It was running just fine the day before.
If I pull the control board, can one often see something burned up on the board. (If the board is bad)
I'm not sure how old the system is.
Would it pay me to set the thermostat to call for heat, go down and shut the power switch to off, turn it back on, and note the start up sequence?
I know the last one I worked on gave you codes.
Furnace isn't working either though, as I set it to the heat mode, and the room temperature is still around 60*

bubinga

Well-known member

OK, MY Bad!
The heat side of the system seems to still be working fine. I don't know, would it still be possible it is still a bad thermostat if the A//C is not working, but the heat is?

dogdog

Well-known member

OK, MY Bad!
The heat side of the system seems to still be working fine. I don't know, would it still be possible it is still a bad thermostat if the A//C is not working, but the heat is?

you were on cooling mode. by default if you set your temp to cooling and your set temp is at 60, your room temp is at 68, the system will turn on, and try to cool the house down to 60deg +/- 3 or what ever that error set at.

if your blower unit on the furnace is running, and the outside compressor fan is working. but your house or the air is not cool, it might be something else.

Normal system, usually only have 1 set of control wires to the outside unit and 24vac to control a contactor / relay for both the 240V condenser fan and compressor. so if that runs, it might not be electrical issue. well at least up to the contactor point (not control electronic issue)

bubinga

Well-known member

you were on cooling mode. by default if you set your temp to cooling and your set temp is at 60, your room temp is at 68, the system will turn on, and try to cool the house down to 60deg +/- 3 or what ever that error set at.

Yes, all of that I understand, and is working properly. And I am setting the Heat/Cooling mode properly, and setting the temperature dial correctly.

if your blower unit on the furnace is running, and the outside compressor fan is working. but your house or the air is not cool, it might be something else.

Normal system, usually only have 1 set of control wires to the outside unit and 24vac to control a contactor / relay for both the 240V condenser fan and compressor. so if that runs, it might not be electrical issue. well at least up to the contactor point (not control electronic issue)

So you are saying if the Blower motor on the furnace is running, and the outside compressor fan is running, I can eliminate the thermostat being the issue?

dogdog

Well-known member

"So you are saying if the Blower motor on the furnace is running, and the outside compressor fan is running, I can eliminate the thermostat being the issue?"

^^^
Yes. It would only be a problem if you are on cooling and your set target temp on thermostat is 68 and outside ambient temp reading is at 60 ( the reverse of what you got) and system turns on. that might be some issue.

There are only one set of control wires to the outdoor condenser / compressor unit. in most home AC systems, "most". if the contactor is engaged, the out door unit contactor is engaged. it's not thermostat issues I would say. all you have left is if the condenser fan running, verify if the compressor is running.. or at least voltage to the compressor. or monitoring the pressure. Usually there is an electrical diagram at the condenser unit panels. "Usually"

but voltage to the contactor and your furnace blower running, heater not engaged, that is normal in cooling mode.

Sorry , not expert enough to trouble shoot refrigerant pressure or calculate super heat those stuff yet. I need to pick that skill up to fix for my parent's place, same situation, blower runs, condenser fan runs, compressor runs (?), not cooling. suspect some bad installer since day one too cheap to purge when brazing the lines. (long story). dunno for sure, it's not been working since day one house was build..

There are few good youtubers doing subjects on super heat and recharging / condenser compressor diag.. one guy from florida Dr. Zyclop or something is great if he is still around. because he explains it, instead of show off with it like most youtuber. So you actually learn something instead of WOW he is amazing and learn learn nothing..

I really hate having to go downstairs just to see if my boiler is on. I have a fancy-schmancy LUX thermostat that some previous owner of my house bought. It can do a lot of amazing things, from telling me when to change some filter that doesn't exist to controlling the air conditioner I do not own. It's fully programmable, but all I need it to do is maintain a single temperature, but it would be really nice if it could tell me when it's calling for heat. Shouldn't be too hard, right? A smart unit like that should know if a set of contacts is open or closed, yet, for some reason it's unwilling to share that information with me. So I'm wondering if there is any thermostat on the market that has this capability, or am I just way out of line for expecting a thermostat to provide me with this kind of esoteric detail?

The village elder, who was also a powerful witch, saw great potential in Luna's magical abilities and took her under her wing. She became Luna's mentor, teaching her the ways of magic and guiding her in understanding and controlling her powers. As Luna grew older, she became more adept at harnessing her magical abilities. She could control the elements, heal the sick, and even communicate with animals. Luna's magical prowess soon became well-known among the villagers, who regarded her with awe and admiration. Despite her magical powers and the acceptance she received from the villagers, Luna still yearned for the love and presence of her biological parents. She often wondered who they were and why they had abandoned her. The unanswered questions weighed heavily on her heart, but she refused to let it define her. Instead, Luna chose to channel her energy into positive actions. She used her powers to protect the village from evil entities and helped those in need whenever she could. Her selflessness and compassion endeared her to the villagers even more, and she became a symbol of hope and inspiration. As time went on, Luna realized that family was not solely defined by blood relation. The villagers had become her family, offering her the love and support she had craved for so long. Luna learned to embrace her identity as a parentless witch and take pride in her unique journey. In the end, Luna's parents' identity remained a mystery, but it no longer held power over her. She had found her place in the village, surrounded by people who loved and appreciated her for who she was. Luna had become the parentless witch who had found a family and, in turn, had become a cherished member of the community..

Reviews for "The Parentless Witch and the Quest for Identity"

1. Sarah - 2 stars - I was really disappointed with "The parentless witch". The characters were underdeveloped and lacked depth, making it hard to connect with them. The storyline was also predictable and felt like it was trying too hard to be magical and whimsical. Overall, I found the book to be quite boring and not worth my time.

2. Michael - 1 star - I found "The parentless witch" to be extremely dull and uninteresting. The plot was slow, lacking any real excitement or suspense. The writing style was also poor, with choppy sentences and awkward phrasing. I couldn't bring myself to finish the book as I simply couldn't get invested in the story or the characters. I would not recommend this book to anyone.

3. Emily - 2 stars - I had high hopes for "The parentless witch" but unfortunately, it fell short of my expectations. The pacing of the book was off, with long periods of nothing happening followed by rushed and unresolved plot points. The world-building was also lacking, leaving me confused and disconnected from the story. While the concept was interesting, the execution was poor and left a lot to be desired. Overall, I was disappointed with this book.

4. David - 2 stars - "The parentless witch" had an intriguing premise, but it failed to deliver. The characters were one-dimensional and lacked any real development, making it difficult to care about their fates. The writing was also subpar, with cliched dialogue and repetitive plot points. The pacing was slow, and the story dragged on unnecessarily. I was left feeling unsatisfied and would not recommend this book to others.

5. Jennifer - 1 star - I really struggled to get through "The parentless witch". The writing was convoluted and confusing, with excessive descriptions that didn't add anything to the story. The plot was unclear and disjointed, making it difficult to follow along. Additionally, the main character was unlikable and made questionable decisions throughout the book. Overall, I found the book to be a chore to read and regretted picking it up.

The Parentless Witch as a Metaphor for Orphanhood